Binder KT 53 User Manual download pdf (Page 51)

KT (E6) 09/2013 Page 51/135

9.3.6 Set-point ramp and set-point step modes

“Ramp” mode

The set-point of a given program section functions as the section’s start temperature. During the section’s

duration, the temperature set-point gradually passes to the set-point of the subsequent program section.

The actual temperature value follows the continually changing set-point. If the last program section is in

“ramp” mode, then you must program an additional section to provide the target temperature. Otherwise,

the corresponding section would be incomplete, i.e., the program would stop one section too early.

Programming in the “ramp” mode allows various kinds of temperature transitions:

• Gradual slow temperature changes

The set-point changes its value gradually during the entered section duration. The actual temperature

value (X) follows the continually moving set-point (W) at any time.

• Constant temperature

The initial values of two subsequent program sections are identical; so the temperature remains

constant during the duration of the first program section.

• Sudden temperature changes

These changes occur rapidly within the minimum amount of time (minimum entry: 1 second).

“Step” mode

The set-point of any program section functions as the section’s target temperature. At the start of the

program section, the unit heats up or cools down with the maximum speed to reach the entered value;

and then it holds it for the remaining section time. The set-point temperature remains constant for the

section’s duration.

Fixed value

08.03.2013 05:05:06

Time program editor.

Select a value under “R/S”

and press the operating button.

..\ Temperature controller

[°C]

No.

Value

H:M:S Ref.

Rep.

T. min

T.max R/S

25.00

00:00:15

-999.00

999.00

Ramp

Fixed value

08.03.2013 05:05:06

Submenu “Ramp/step“.

Select the desired function

and press the operating button.

“Ramp” = Setpoint ramp mode selected

“Step” = Setpoint step mode selected

..\ Ramp/step

Ramp

Step

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 134 135

Comments to this Manuals

No comments

Binder KT 53 User Manual Page 51

Comments to this Manuals

Related products and manuals for Equipment Binder KT 53