KT (E6) 09/2013 Page 107/135
17.3.2 Setting the Safety controller
To display and to change the current safety controller settings in the “safety controller” submenu, go to
Menu > Safety controller
Selection between Limit (absolute) and Offset (relative) safety controller mode
08.03.2013 05:05:06
Submenu “Safety controller”.
Select “Mode”
and press the operating button.
Close Home
08.03.2013 05:05:06
Submenu “Safety controller mode”.
The current safety controller mode is displayed:
“Limit (absolute)” or “Offset (relative)”
To change the mode, press the operating button.
The modified safety controller mode is displayed.
..\ Safety controller mode
Close Home
When changing the safety controller mode, the safety controller setpoint which had been active
before in this mode becomes active again.
Entering the safety controller setpoint for overtemperature
08.03.2013 05:05:06
Submenu “Safety controller”
Select “Overtemperature“
and press the operating button.
Close Home
Comments to this Manuals