Binder BF 53 User Manual download pdf (Page 20)

BF (E1) 02/2015 page 20/51

5. Press

button to return to normal display (actual value display) (automatically after approx. 30

seconds).

Adjust the temperature safety device following any changes of the set-point (chap. 7).

6.2 Display / entry of temperature and ventilation set-points (with selected

temperature ramp)

If previously a temperature ramp value has been selected (chap. 6.4.2):

Press button

in normal display / actual value display during ramp operation to have displayed the

actual ramp temperature set-point changing according to the selected gradient in addition to the entered

final set-points for temperature and fan speed.

The incubator is operating, the controller is in normal display (actual value

display). The actual temperature value (example: 21.8 °C) is displayed:

1. Press

button

The display shows alternately “SPr” and the actual temperature ramp set-point changing according

to the selected gradient (example: 42.7 °C):

This ramp set-point is only displayed, not adjustable.

2. Press

button

The display shows alternately “SP” and the previous temperature set-point (example: 60 °C):

3. With the

buttons enter a set-point value between 0 and 100.

The desired temperature set-point can be selected in a temperature range from 5 °C /

9 °F above room temperature up to 100 °C / 212 °F.

Wait 2 seconds until the entered temperature value is taken over (display flashing once).

4. Press

button to proceed to the fan speed entry.

The display shows alternately “n” and the previous fan speed set-point (example: 100%):

5. Set the desired fan speed with the

buttons

The fan speed can be set to a value between 0% and 100%.

Wait 2 seconds until the entered value is taken over (display flashing once).

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 50 51

No comments

Binder BF 53 User Manual Page 20